Stripping

Exploring the: Stripping Zone

5 Results for: Experts

Sort by:
Published: 11/3/2016

Anodizing: Corrosion on Hardcoat Anodized 7000 Series Forging
Q. I sent you photos of two parts that are alloy 7050 forgings. On these parts there are spots that appeared as a result of Type III (hardcoat) anodizing that were not present before anodizing. They look like corrosion of some sort, but the corrosio...

Published: 2/1/2016

Anodizing: Stripping Type III (Hard) Anodic Coatings
Q. Is it possible to strip hard coat type III anodized coatings?

Published: 8/1/2014

Stripping Type III (Hardcoat) Anodic Coatings
Is there an effective way to strip Type III (hardcoat) anodic coating from parts while removing as little substrate as possible?

Published: 11/1/2006

Rough, Uneven Surface After Stripping
Question: Sometimes after using the caustic etch to strip the anodic coating off parts that are being reworked, we have noticed blotchy areas on the parts.

Published: 8/1/2006

Etching Prior to Chromate Conversion Coatings
Question: We are planning to install a chromate conversion coating line using the standard hex chrome process.