« Prev | | Next »

Sort by:


Ultrafiltration in Electrocoating Becoming Critical
UF it closes the mass balance of the process while producing rinse waters from the electrocoat paint bath, often resulting in 95 percent or higher transfer efficiencies with no net water addition.
Article Published: 8/1/2012
NASF REPORT: Is EPA Playing Dirty With Chromium Data?
NASF’s Jeff Hannapel and Christian Richter point to major flaws, bad precedent in EPA chromium air rule. NASF leaders have submitted a 100-page package of comments to the EPA in response to the agency’s proposed rule for chromium finishing operation...
Article Published: 5/1/2012
PPG Industries, AkzoNobel Launch New Aerospace Coating Products
The Aerocron primer from PPG’s aerospace coatings group is the first e-coat primer for airframe manufacturers and subcontractors; AkzoNobel’ Metaflex SP brand is a result of a two-year partnership between AkzoNobel Aerospace Coatings and Pantheon En...
Article Published: 5/1/2012
Sand + Snow Makes Pretreatment Essential
Polaris' finishing department made sure its cleaning and pretreatment process was doing the job right before they electrocoated and powder coated popular off-road vehicles, snowmobiles, motorcycles and military vehicles. SEE THE VIDEO
Article Published: 5/1/2012
New Engines Drive Parts Cleaning Innovation
When Cummins began designing its new operations at its Indiana plant, the company made the decision to not skip over the small details, which included making sure that its parts cleaning and deburring were just as sophisticated as its machining oper...
Article Published: 4/1/2012
Meeting the Critical Cleaning Challenge
Today’s parts cleaning industry faces numerous challenges that can make the selection of an effective critical cleaning system difficult
Article Published: 4/1/2012
Solving Wide-Body E-Coat Immersion Problems
Altec Industries in Burnsville, N.C., a manufacturer of heavy truck bodies and related equipment, added e-coat to its finishing operation and—through the proper design and execution of an electrocoat/liquid spray topcoat paint system —addressed issu...
Article Published: 4/1/2012
Are Ionic Liquids Right for Your Parts Cleaning Job?
Ionic liquids have also been considered for parts cleaning applications because of their negligible vapor pressure, high thermal and electrochemical stability, and low melting points of less than 100°C.
Article Published: 4/1/2012
Product Quality Means Better Cleaning
Choosing an Aqueous Parts Washing System: As machining technology has advanced, expectations for product quality have increased as well. But better finishes and tighter tolerances are not the only goals. The need for meeting more stringent cleaning ...
Article Published: 3/1/2012
Just How Clean Is Clean?
Most finishing consultants have lost count of the number of times that inadequate cleaning and pretreatment was the cause of defective painting or plating. Skip plating, blistering, delamination—these are just some of the commonly found defects caus...
Article Published: 2/1/2012

« Prev | | Next »


Calvary Industries
Kyzen Corporation - KYZEN

Suppliers | Products | Experts | News | Articles | Calendar | Process Zones

The Voice of the Finishing Industry Since 1936 Copyright © Gardner Business Media, Inc. 2014

Subscribe | Advertise | Contact Us | All Rights Reserved