« Prev | | Next »

Sort by:


Minimizing Frequency of OSHA Inspections
A safety program goes a long way to reduce accidents, worker complaints and violations, and to comply with OSHA regulations—all of which should lead to a reduced need for OSHA to inspect your facility.
Ask an Expert Published: 3/27/2014
Take Employee Complaints Seriously
When complaints are ignored by the employer, the worker often complains to EPA or OSHA, or, worse, an accident occurs.
Ask an Expert Published: 3/20/2014
SBA Mentor-Protégé Program
Will the federal mentor-protégé programs help improve a small business' chances for a federal contract?
Ask an Expert Published: 9/24/2013
Guarding Against Counterfeit Parts
We have been doing a lot of defense work lately and are concerned about counterfeit parts. How can we protect ourselves?
Ask an Expert Published: 7/1/2013
Supplier Contracts
Can we (the supplier) refuse to agree to early termination of a contract unless the customer agrees to increased prices or other concessions?
Ask an Expert Published: 7/1/2013
Nitrites and Fragrances
We are using a vibratory finishing compound that has been satisfactory for more than 20 years. Recently, a potential new vendor pointed out that it contains sodium nitrite and said we are violating the law in using it. We checked with our supplier, ...
Ask an Expert Published: 1/26/2012
Stench!
When our mass finishing equipment is started after being shut down a week or more, an extreme stench emanates from the entire system. How can we control this problem?
Ask an Expert Published: 1/25/2012
Improving Appearance of Aluminum
Can mass finishing provide a nice looking, shiny part at a reasonable cost?
Ask an Expert Published: 3/31/2011
Monitoring Compound Concentration
How can we continuously monitor our mass finishing fluid?
Ask an Expert Published: 3/31/2011
Phosphates in Wastewater
I am charged with finding the sources of phosphorus in our plant. Our main process effluents are from mass finishing and washing machines. I have not found significant phosphorus in these fluids, and yet, we are close to the limit. What am I missing...
Ask an Expert Published: 1/11/2011

« Prev | | Next »


Schaffner Mfg. Co., Inc.

Suppliers | Products | Experts | News | Articles | Calendar | Process Zones

The Voice of the Finishing Industry Since 1936 Copyright © Gardner Business Media, Inc. 2014

Subscribe | Advertise | Contact Us | All Rights Reserved