[ Log On ]
Exploring the: Vibratory Finishing Zone
|
Sort by: |
- Media Lodging
- Ceramic media chips and small media are lodging in the parts during our vibratory process. How can we prevent or eliminate these problems?
Ask an Expert Published: 3/25/2013
- Finishing Aluminum Parts
- We are machining a 6-inch, complex-shaped, 6061 aluminum part. We need to further improve the surface finish from the machined 32 Ra to 12 Ra, maintaining a uniform, pleasant finish. What finish system should we consider?
Ask an Expert Published: 3/19/2013
- Applications for Plastic Media
- Q.
Ask an Expert Published: 9/28/2012
- Customer Wants Burnished Finish
- A customer has asked us to provide a shiny, burnished finish to powdered metal parts.
Ask an Expert Published: 7/3/2012
- Optimizing Compound Flow Rates
- We operate six round vibratory finishers that range in size from 3 to 25 cu ft. Compound is fed to each machine from a central mixing system, each machine having from one to four nozzles to feed the compound. Four of the machines are hand loaded and...
Ask an Expert Published: 3/30/2012
- Nitrites and Fragrances
- We are using a vibratory finishing compound that has been satisfactory for more than 20 years. Recently, a potential new vendor pointed out that it contains sodium nitrite and said we are violating the law in using it. We checked with our supplier, ...
Ask an Expert Published: 1/26/2012
- Selecting a Vibratory Finisher
- Can you recommend selection criteria for buying vibratory finishing machines?
Ask an Expert Published: 1/10/2011
- Cylinders Take a Tumble
- In your April column, you strongly recommended against cylinder media. Yet, in the same and other publications, many other articles on media selection refer to the popularity of cylinders, and they often recommend them for hole deburring and general...
Ask an Expert Published: 7/1/2010
- Tips for Green Mass Finishing
- In your area, mass finishing, can you give me some guidelines to reduce the use of non-renewable resources?
Ask an Expert Published: 1/1/2010
- Vibratory Parts Washer
- A new manufacturing engineer with our firm suggested that we look into a vibratory/washing operation, perhaps even replacing the deburring machine.
Can you comment on this?
Ask an Expert Published: 1/1/2010
Loading the player ...
