« Prev | | Next »

Sort by:


Plating Stainless Steel
We plate carbon steel with brass, and our process consists of hydrochloric acid pickling, rinse, cyanide brass plating, or copper and zinc followed by diffusion. Would it be possible to plate stainless steel with the same process?
Ask an Expert Published: 5/9/2013
Painting Transformer Radiators
Can you recommend a reliable company that can supply the equipment and install a line that would be able to paint corrugated tank radiators?
Ask an Expert Published: 5/8/2013
Recycling Metals
Is there a process or commercial equipment to electrodeposit Zn, Ni, Cr, Fe, and remove the heavy metals from the wastewater?
Ask an Expert Published: 5/7/2013
Black, Pitted Areas on Anodized Parts
We anodize aluminum cookware and have recently been getting parts with black pits scattered all over them. What is this and how might it be happening?
Ask an Expert Published: 5/6/2013
Humidity Levels for Powder Application
Could our problems with powder application be extremely low humidity levels during the winter?
Ask an Expert Published: 5/3/2013
“Water-Break-Free” Test
What is a “water-break failure” test?
Ask an Expert Published: 5/3/2013
Stripping Copper-Nickel-Chrome
Is there a method for stripping copper-nickel-chrome deposits from rejected zinc diecastings?
Ask an Expert Published: 5/2/2013
Water-Wash Spray in Cold Climates
Can we safely install a water curtain spray booth at a factory in Russia? Won’t the spray booth water start to freeze when the temperature reaches 0ºC? Is it not more advisable to install a dry filter booth in this climate?
Ask an Expert Published: 5/1/2013
Treating for BOD from E-Coat
What is the most effective treatment for reducing BOD anolyte? Is a small carbon absorption unit on the overflow line the solution?
Ask an Expert Published: 4/30/2013
Sealing Parts After Two Months
Is it possible and practical to seal hardcoat anodized (Type III) parts that have been in storage for about two months?
Ask an Expert Published: 4/29/2013

« Prev | | Next »


Suppliers | Products | Experts | News | Articles | Calendar | Process Zones

The Voice of the Finishing Industry Since 1936 Copyright © Gardner Business Media, Inc. 2013

Subscribe | Advertise | Contact Us | All Rights Reserved