[ Log On ]
Exploring the: Plant Management Zone
|
Sort by: |
- Painting Transformer Radiators
- Can you recommend a reliable company that can supply the equipment and install a line that would be able to paint corrugated tank radiators?
Ask an Expert Published: 5/8/2013
- Water-Wash Spray in Cold Climates
- Can we safely install a water curtain spray booth at a factory in Russia? Won’t the spray booth water start to freeze when the temperature reaches 0ºC? Is it not more advisable to install a dry filter booth in this climate?
Ask an Expert Published: 5/1/2013
- Enclosed Spray Booth
- We are located in southern India, where the normal temperature is 30-40°C. How can we control the humidity and temperature in our spray paint booth?
Ask an Expert Published: 10/2/2012
- Sanding in the Finishing Area
- Is it standard practice to allow sanding in areas where the final top coat is sprayed?
Ask an Expert Published: 9/13/2012
- Fish Eyes
- I recently have been having a problem with fish eyes when spraying epoxy paint, Mil PRF-22750F, FED color #24052.
Ask an Expert Published: 2/1/2012
- Adhesion to Aluminum
- Our problem is poor adhesion (paint flaking) around the sheared areas and punched holes.
Ask an Expert Published: 9/22/2011
- Painting Aluminum Tubes
- In our product line we have an aluminum tube being used as an extension for a carbon mast. We have been painting this tube with white paint, but are having problems with the paint’s durability, as it is chipping.
Ask an Expert Published: 6/1/2011
- Spray Booth and Oven Information
- I need information about different types of paint spray booths (dry filter, water wash, powder coating spray booth, etc.) and the various types of paint curing ovens. Would you please point me in the direction of some good resources?
Ask an Expert Published: 6/1/2011
- Flash Rusting
- Our problem is that right after the acid pickle, the tanks flash rust severely before we can get them into the zinc phosphate solution.
Ask an Expert Published: 6/1/2011
- Gas vs. Electric Ovens
- What are the pros and cons for using gas or electric to heat a typical automotive supplier curing oven?
Ask an Expert Published: 5/1/2011