[ Log On ]
Exploring the: Nickel Plating Zone
|
Sort by: |
- Plating Copper Bus Bars
- Why are the copper bus bars in our plating facility nickel-plated?
Ask an Expert Published: 5/14/2013
- Flaking Nickel
- Our stripping process sometimes does not remove all of the nickel plate. When re-plated, the areas that still have “old” nickel on the surface tend to flake. Do you have any suggestions for solving this problem?
Ask an Expert Published: 5/10/2013
- Pitted and Rough Nickel Plate
- How can I remove roughness and pitting in my Watts nickel plating bath?
Ask an Expert Published: 2/25/2013
- Low-Stress Nickel Deposit
- What is a low-stress nickel deposit?
Ask an Expert Published: 2/22/2013
- Low-Stress Nickel Deposit
- What is a low-stress nickel deposit?
Ask an Expert Published: 2/22/2013
- Bright Nickel Problems
- My bright nickel plating bath is giving me a lot of grief. Our problem is the lack of uniform brightness on the part. The side of the part directly facing the anode is bright in some cases but not others. If I attempt to plate multiple parts in the ...
Ask an Expert Published: 11/30/2012
- Electroless Nickel on Tungsten
- Can one apply electroless nickel over a tungsten metal matrix?
Ask an Expert Published: 11/9/2012
- Pits in Electroless Nickel
- We are plating electroless nickel (EN) on leaded brass, but find pits in the EN layer. What is the best way to prepare the leaded brass substrate so that we do not get a pitted finish?
Ask an Expert Published: 10/5/2012
- Green Sludge in Nickel Tank
- I have green sludge collecting on the filters in my nickel plating bath. What is it, and what can I do to prevent this from happening in the future?
Ask an Expert Published: 10/4/2012
- Tin Plate on Zinc/Nickel Deposit
- Our company produces components made from mild steel that are nickel/zinc plated. We have been asked to investigate the possibility of over-plating of a tin strip on these parts. Can this be done, and can it be done selectively?
Ask an Expert Published: 9/24/2012