« Prev | | Next »

Sort by:

Compatibility of Tribo Application with Coronal Application
Why won't the powder penetrate into Faraday areas?
Ask an Expert Published: 7/1/2015
Application of a Second Coat of Powder
Why am I not getting good attraction to the surface or a consistent second coat?
Ask an Expert Published: 6/1/2015
Comparing Blasting to Conversion Coatings
How complicated is it to apply a phosphate coating?
Ask an Expert Published: 6/1/2015
Testing to Compare Powder against Liquid Paint
Do you know of any testing that has been done to compare powder coating to outdoor exposure specifications?
Ask an Expert Published: 4/1/2015
AAMA Specifications and Aluminum Railing
Is it correct to assume that AAMA 2604 is suitable for an aluminum railing application and AAMA 2605 is not?
Ask an Expert Published: 4/1/2015
Impact of Heat on Chromate Conversion Coating
Will the internal trivalent chromate conversion coatings that are not protected by the CARC paint degrade and become less non-conductive or resistant to corrosion?
Ask an Expert Published: 4/1/2015
Powder on the Seacoast
After about 18 months of exposure, the powder coating has deteriorated and broken down. There are areas where the coating is blistering, and exposed metal is beginning to rust. Can you give us any advice or information as to why the coating may have...
Ask an Expert Published: 3/1/2015
What Issues Affect Transfer Efficiency?
My boss has asked me to develop a plan to improve our transfer efficiency on our powder line. Our 12 automatic guns are over six years old and we have pretty good success with them. According to what I hear and read we should be getting better resul...
Ask an Expert Published: 2/1/2015
How to Remove Powder from a Mask
What is the best way to quickly and effectively remove powder residue from magnets so it can be reused without leaving powder residue on the surface of the next part?
Ask an Expert Published: 2/1/2015
Cause of Porosity
What is the most common cause of porosity on a powder coated surface and how much porosity is considered acceptable?
Ask an Expert Published: 12/1/2014

« Prev | | Next »

Suppliers | Products | Experts | News | Articles | Calendar | Process Zones

The Voice of the Finishing Industry Since 1936 Copyright © Gardner Business Media, Inc. 2015

Subscribe | Advertise | Contact Us | All Rights Reserved