xxx


« Prev | | Next »

Sort by:


Powder Clinic: Containment Air Velocity
Q. What is the correct containment air velocity in a powder booth?
Ask an Expert Published: 8/23/2016
Powder Clinic: Pinholes Mentioned in July Issue
Q. Just read the article in most recent issue of PF about our problem and wanted to respond with what we found out.
Ask an Expert Published: 8/23/2016
Powder Clinic: Is Blasting Enough for Preparation?
Q. I am looking into making the switch from liquid to powder coating. I have an experienced powder coater who says all my aluminum and steel parts need is to be blasted, and that should be good enough. But I am finding mixed reviews online. So is th...
Ask an Expert Published: 8/23/2016
Powder Clinic: Adhesion of Powder to Brass
Q. I’ve heard from a few vendors that brass presents challenges with adhesion, whereas steel and aluminum do not. What is the reason for this?
Ask an Expert Published: 8/1/2016
Powder Clinic: Outdoor Durable Powder
Q. We have a large job that requires protection from sunlight. What kind of powder we should use?
Ask an Expert Published: 7/1/2016
Powder Coating Q&A: Micro-Porosity in Cured Coating
When our parts are inspected, there seem to be thousands of very small pin pricks.
Ask an Expert Published: 6/1/2016
Powder Coating Q&A: Requirements for Breathing PPE in a Powder Operation
What kind of breathing protection is required for compliance with health and safety standards?
Ask an Expert Published: 6/1/2016
The Best Method for Coating Aluminum Extrusions
How do powder coaters paint for less than liquid paint? And which is better, at high volume production, a vertical line, or a horizontal line?
Ask an Expert Published: 3/1/2015
Powder on Anodized Aluminum
Is there a powder coating that will hold up to Skydrol 500 B4 and Skydrol LD4
Ask an Expert Published: 3/1/2015
Coating to Hide Blemishes
Is powder coating suitable for a polypropylene part with deep recesses?
Ask an Expert Published: 12/1/2014

« Prev | | Next »


Suppliers | Products | Experts | News | Articles | Calendar | Process Zones

The Voice of the Finishing Industry Since 1936 Copyright © Gardner Business Media, Inc. 2016

Subscribe | Advertise | Contact Us | All Rights Reserved