xxx


« Prev | | Next »

Sort by:


Powder Clinic: Adhesion of Powder to Brass
Q. I’ve heard from a few vendors that brass presents challenges with adhesion, whereas steel and aluminum do not. What is the reason for this?
Ask an Expert Published: 8/1/2016
Powder Clinic: Outdoor Durable Powder
Q. We have a large job that requires protection from sunlight. What kind of powder we should use?
Ask an Expert Published: 7/1/2016
Powder Coating Q&A: Micro-Porosity in Cured Coating
When our parts are inspected, there seem to be thousands of very small pin pricks.
Ask an Expert Published: 6/1/2016
Powder Coating Q&A: Requirements for Breathing PPE in a Powder Operation
What kind of breathing protection is required for compliance with health and safety standards?
Ask an Expert Published: 6/1/2016
The Best Method for Coating Aluminum Extrusions
How do powder coaters paint for less than liquid paint? And which is better, at high volume production, a vertical line, or a horizontal line?
Ask an Expert Published: 3/1/2015
Powder on Anodized Aluminum
Is there a powder coating that will hold up to Skydrol 500 B4 and Skydrol LD4
Ask an Expert Published: 3/1/2015
Coating to Hide Blemishes
Is powder coating suitable for a polypropylene part with deep recesses?
Ask an Expert Published: 12/1/2014
Cause of Porosity
What is the most common cause of porosity on a powder coated surface and how much porosity is considered acceptable?
Ask an Expert Published: 12/1/2014
Powder on Plastic Parts
We have heard that some companies are applying powder coating to plastic parts. Is this true?
Ask an Expert Published: 9/1/2014
Powder Over Galvanized Steel
Is a "duplex" system of powder over hot dip galvanized steel common?
Ask an Expert Published: 5/23/2014

« Prev | | Next »


Suppliers | Products | Experts | News | Articles | Calendar | Process Zones

The Voice of the Finishing Industry Since 1936 Copyright © Gardner Business Media, Inc. 2016

Subscribe | Advertise | Contact Us | All Rights Reserved