Anodizing

Exploring the: Anodizing Zone

7 Results for: Whitepaper

Sort by:
Published: 10/16/2015

The Behavior of Intermetallic Compounds in Aluminum during Sulfuric Acid Anodizing Part 2: Al-Cu, Al-Mg, Al-Si, Al-Ti, Al-Fe-Si, Al-Zn-Mg Alloys
The 1971 Carl E. Huessner Gold Medal Award was given to J. Cote and co-workers for the Best Paper appearing in Plating or the AES Technical Proceedings in 1970. Actually a two-part paper beginning in 1969, the second installment of the paper from 1...

Published: 10/16/2015

The Behavior of Intermetallic Compounds in Aluminum during Sulfuric Acid Anodizing, Part 1: Al-Mn, Al-Fe, Al-Mg2Si, Al-Cr Alloys
The 1971 Carl E. Huessner Gold Medal Award was given to J. Cote and co-workers for the Best Paper appearing in Plating or the AES Technical Proceedings in 1970. Actually a two-part paper beginning in 1969, the first installment of the paper is repu...

Published: 10/17/2014

Aluminum Surface Finishing Corrosion Causes and Troubleshooting
In this paper, a review of several process solutions, examining coolants, solvent cleaning, alkaline clean/etch and deoxidizing/desmutting, listing intended and unintended chemical reactions along with possible mechanisms that would favor corrosion ...

Published: 3/1/2013

Hexavalent Chromium - What Else?
Dr. Patrick Benaben won the 2011 NASF Scientific Achievement Award. Here is an edited version of his presentation at NASF SUR/FIN 2012, along with commentary provided by Dr. James H. Lindsay, Technical Editor for the NASF.

Published: 2/13/2013

Development of Life Prediction Models for High Strength Steel in a Hydrogen Emitting Environment
Solvent substitution for maintenance and overhaul operations of military systems has been a primary environmental concern for many years. Cadmium replacement in these systems has been targeted for decades. Both of these areas have a common obstacle ...

Published: 6/1/2012

The Leading Edge Guide to Top Quality Anodizing using the Complete Spectrum Approach with a Universal Type I – II – III – (123) Mixed Electrolyte
This paper discusses a new advanced problem solving anodize technology for processing Types I, II and III anodize (A123) in a universal mixed electrolyte.

Published: 8/18/2011

Investigation of Tin Whisker Formation
Immersion tin and lead-free hot air solder leveling (HASL) coatings based on SnCu or SnAgCu alloys are widely used as surface finish materials for printed circuit boards (PCB). These coatings prevent the underlying copper from corrosion and preserve...