Electroplating

Exploring the: Electroplating Zone

750 Results for: Article

Sort by:
Published: 6/14/2019

Makeover Reaps Rewards for New Mexico Plating Shop
Manufacturing Extension Partnership gave Theta Plate a blueprint for its manufacturing process and helped it see where efficiencies could be introduced, in a process called value stream mapping.

Published: 6/14/2019

Electrolytic Versus Electroless Nickel Plating
Electroless and electrolytic nickel platings are effective at significantly improving a part’s strength and durability, but the differences between the two processes are important to distinguish.

Published: 6/14/2019

Solving the Challenge of Carbonate Buildup in Zinc-Nickel Plating Baths
Plating shop designs a refrigerated drum crystallization method with a flow-through tank that treats a continuous flow of plating bath rather than separate batches.

Published: 6/1/2019

Changes Bring Out the Best for Plating Shop
Arizona’s CRC Surface Technologies Improves Performance, Profits with Management Changes

Published: 6/1/2019

Impact of Intermetallic Species on Cast Aluminum Alloys for Anodizing Applications
Alloys with higher silicon concentrations can inhibit the growth of anodic oxide films under galvanostatic and potentiostatic conditions.

Published: 5/19/2019

The Relationship Between Vickers Hardness and Universal Hardness
The Vickers indenter hardness test, based on indenter displacement under test load (universal hardness), is being used for an increasing number of applications.  The new method is also subject to much discussion among the experts.  An impo...

Published: 5/19/2019

Evaluation of a Simple Thin-Film Ductility Tester and Review of the Ductility of Nickel Sulfamate Deposits
Originally published in 1992, this paper addressed a critical issue in the science of electroforming, that of the measurement and control of deposit ductility.

Published: 5/13/2019

Electrocodeposition of MCrAlY Coatings for Advanced Gas Turbine Applications - 5th Quarterly Research Report
The objective of the work is to study and optimize the MCrAlY electrocodeposition process to improve the coating oxidation/corrosion performance. In this quarter, work focused on preparation and characterization of CrAlY-based alloy powders for...

Published: 5/1/2019

New Technology, Equipment Boost Green Bay Anodizing
This past year, the shop installed a 5-tank, hardcoat anodizing line; computerized tracking software; and natural gas dryer that dries parts in less than 10 minutes.

Published: 5/1/2019

Youth Movement Spurs Aerodynamics Metal Finishing
A 30-employee shop is 50 percent millennials and 50 percent females as it recruits people who fit into their dynamic, instead of taking applications at the door.