Mechanical Finishing

Exploring the: Mechanical Finishing Zone

59 Results for: Article

Sort by:
Published: 2/1/2003

Cleaning Used Hooks & Racks
In my column for December 2001, I outlined some possible paint stripping solutions for R.R.

Published: 10/1/2002

Used Media
Question: We use 5/8 x 1 inch ceramic cylinders.

Published: 10/1/2002

Damage of Heavy Parts in Vibratory Finisher
Question: We make bronze castings that have two flat ground surfaces and several drilled and tapped holes.

Published: 7/1/2002

Removing Solids from the Waste Stream
Question: We have several vibratory finishing machines using a fast cutting ceramic media.

Published: 7/1/2002

High Consumption of Steel Shot in Wheel Blaster
Question: We have two large tumble-style wheel blast machines of similar capacity and horsepower, but one machine consumes almost twice as much abrasive as the other.

Published: 6/1/2002

Loop ’d Loop
Amusement park ride or industrial process?

Published: 2/1/2002

Polishing Stainless Steel Screws Revisited
To the readers: In my June 2001 column I answered a question regarding options to polish stainless steel screws.

Published: 2/1/2002

Anodizing of Diecast Aluminum
Question: Our company uses a lot of diecast aluminum parts now for agricultural water application equipment such as big gun sprinklers and valves.

Published: 2/1/2002

Info on PM&M?
Question: I just bought a used sandblasting cabinet and need a manual for it.

Published: 10/1/2001

Separation
Much has been written about media selection.