Liquid Coating

Exploring the: Liquid Coating Zone

466 Results for: Article

Sort by:
Published: 7/1/2012

Measuring Up On Coating Thickness
Fischer Technology’s DataCenter software eases measurement requirements, giving reasons why management guru W. Edwards Deming said: “If I had to reduce my message for management to just a few words, I’d say it all had to do with re...

Published: 7/1/2012

Co-Cure to the Rescue For A-Coat and Powder Coating
Henkel’s autodeposition protection technology is an alternative vehicle coating, as Android hopes to produce 9,000 vehicles this year for Florida-based Vehicle Production Group.

Published: 6/1/2012

Accelerating Topcoats for Aerospace Specifications
Bayer’s UV-A curable coatings provide rapid cure rate, high performance

Published: 6/1/2012

Painting Proportioners Becoming Popular With Finishers
Offer high ratio accuracy, various flow rates

Published: 5/1/2012

PPG Industries, AkzoNobel Launch New Aerospace Coating Products
The Aerocron primer from PPG’s aerospace coatings group is the first e-coat primer for airframe manufacturers and subcontractors; AkzoNobel’ Metaflex SP brand is a result of a two-year partnership between AkzoNobel Aerospace Coatings and...

Published: 5/1/2012

EPA One Step Closer to Finalizing New Emission Standards
Attorney and environmental expert Anthony Giuliani explains the EPA's new chromium rules due in 2012, which would amend the existing National Emission Standards for Hazardous Air Pollutants Emissions for hard and decorative chromium electroplati...

Published: 5/1/2012

Finding Lost Profits In Your Finishing Line
The finishing division of White Castle restaurants teamed with Profit Finders, a continuous improvement company specializing in data collection and analysis, to look at ways to increase process efficiencies.

Published: 5/1/2012

NASF REPORT: Is EPA Playing Dirty With Chromium Data?
NASF’s Jeff Hannapel and Christian Richter point to major flaws, bad precedent in EPA chromium air rule. NASF leaders have submitted a 100-page package of comments to the EPA in response to the agency’s proposed rule for chromium finishi...

Published: 5/1/2012

Sand + Snow Makes Pretreatment Essential
Polaris' finishing department made sure its cleaning and pretreatment process was doing the job right before they electrocoated and powder coated popular off-road vehicles, snowmobiles, motorcycles and military vehicles. SEE THE VIDEO

Published: 4/23/2012

Masking for Surface Finishing
Masking is employed in most any metal finishing operation where only a specifically defined area of the surface of a part must be exposed to a process. Conversely, masking may be employed on a surface where treatment is either not required or m...