Powder Coating

Exploring the: Powder Coating Zone

419 Results for: Experts

Sort by:
Published: 10/1/2016

Powder Clinic: Powder Versus Galvanizing
Powder Coating or Galvanizing: Which offers the best long-term protection from corrosion?

Published: 10/1/2016

Powder Clinic: Batch Cure Oven Noise Issue
What is that Noise from My Oven? Expert Rodger Talbert explains that it is difficult to be sure at all without seeing the oven and hearing the noise. However, he thinks it may be related to the pressure settings on the gas train.

Published: 10/1/2016

Powder Clinic: Why Not to Convert Liquid Paint Booth to Powder
Can I Convert a Liquid Paint Booth to a Powder Booth?

Published: 10/1/2016

Parts Cleaning Clinic: Zinc Shot Blasting, Zinc Plating Alternatives
David S. Peterson talks zinc shot blasting, zinc plating alternatives, and advantages to reducing the heating of alkaline cleaners.

Published: 8/23/2016

Powder Clinic: Pinholes Mentioned in July Issue
Q. Just read the article in most recent issue of PF about our problem and wanted to respond with what we found out.

Published: 8/23/2016

Powder Clinic: Is Blasting Enough for Preparation?
Q. I am looking into making the switch from liquid to powder coating. I have an experienced powder coater who says all my aluminum and steel parts need is to be blasted, and that should be good enough. But I am finding mixed reviews online. So is th...

Published: 8/1/2016

Powder Clinic: Adhesion of Powder to Brass
Q. I’ve heard from a few vendors that brass presents challenges with adhesion, whereas steel and aluminum do not. What is the reason for this?

Published: 7/1/2016

Time for a Federal Contractor Reality Check
The economic benefits of a federal contractor status can be significant; the federal government awarded over $445 billion in contracts in the 2014 fiscal year.

Published: 7/1/2016

Powder Clinic: Outdoor Durable Powder
Q. We have a large job that requires protection from sunlight. What kind of powder we should use?

Published: 6/1/2016

Powder Coating Q&A: Micro-Porosity in Cured Coating
When our parts are inspected, there seem to be thousands of very small pin pricks.