Pretreatment for Painting
Avoid Painting the Conveyor II
Question: With reference to your letter in the October issue, I have a comment regarding overspray on racks, etc.
Read MoreInconsistent Gloss Problem
Question: Regarding the letter from T.B. in the October Painting Clinic, I had run across a similar fouling in the oven that would cause an inconsistent gloss.
Read MoreDye Sublimation Coating
Question: I am looking for a supplier of a clear polyester type coating to be applied over a glazed ceramic substrate (tiles, mugs, etc.) to which I will then apply an image using dye sublimation.
Read MoreZinc Phosphate Application
Question: We have been asked to apply a zinc phosphate to steel surfaces in one of our products.
Read MoreOn My Mind: Organizational Lenses
Organizations are commonly analyzed using three perspectives or lenses: strategic, political and cultural.
Read MoreNon-Paint Painting
Question: I'm trying to determine the best way to finish my 1,500 linear ft of oak 3-board fencing.
Read MoreSimple Spray Booth
Question: We are dealers in water pumps, and we make pump banks on steel frames or base plates.
Read MoreStripping Mobile Phones
Question: I have an enquiry at present for reconditioning mobile phones.
Read MoreOld Electrostatic Cable
Question: Where can I find 100 kV cable for my electrostatic paint system that has 1 mm or 0.062-inch stranded conductor in a 0.375-inch polyethylene insulation.
Read MoreZinc-Rich Coatings
Question: I read an article some time back about the relative merits of zinc-rich epoxy coatings vs. inorganic zinc coatings.
Read More
