Submersible Centrifugal Pump Safely Dry Runs
The Renner RT-VC series is expanding to include the RT-VC 300, which saves space through compact design in addition to good performance.
#surfin
Edited by
Photo Credit: Flux Pumps USA
The Renner RT-VC series from Flux Pumps (Flux) has expanded to include the RT-VC 300 submersible centrifugal pump. Incorporating a compact design intended to save space, the centrifugal pump is capable of immersion depths of up to 23" (600mm) alongside the ability to run dry indefinitely, according to the company.
When compared to the traditional immersion pumps, this is effectively 4" longer (100 mm) with similar performance and dry-running safety. In addition, the RT-VC 300 performs well because of its optimized flow channels and impeller geometry, which results in extremely smooth operation over the entire performance curve, Flux says.
Flux Pumps USA | 404-691-6010 | fluxpumpsusa.com | Booth 645
RELATED CONTENT
-
A Protective Decorative Electrolytic Coloring Process for Aluminum
The main task of this work was to study the influence of the different parameters on the electrolytic coloring process for aluminum.
-
Defects in Hard Chromium Deposits Part I: Causes and Cures
The causes of and remedies for defects in hard chromium deposits are explored in the first of this two-part P&SF article from 1984. Photomicrographs and SEM (scanning electron microscope) photographs will illustrate that most defects in various hard chromium deposits arise from defects in the basis metal. These defects may be in the original metal surface or may be caused by preplate finishing. Homogeneous hard chromium deposits can be produced only by eliminating these defects. Practical suggestions and procedures will be given.
-
A Pulse/Pulse Reverse Electrolytic Approach to Electropolishing and Through-Mask Electroetching
Research at the authors’ laboratories has focused on pulse/pulse reverse electrolysis on cathodic processes, such as hard chromium plating from non-hexavalent chemistries. This papers describes studies into pulse/pulse reverse electrolysis as applied to electrochemical metal removal processes, such as electropolishing and electroetching.