Electroplating

Exploring the: Electroplating Zone

744 Results for: Article

Sort by:
Published: 1/1/2018

Leveling the Field in Nickel Plating
Profilometry helps determine the leveling characteristics of Watts nickel baths.

Published: 12/19/2017

Additive Manufacturing and Surface Finishing - The 53rd William Blum Lecture
This presentation is the 53rd William Blum Lecture, presented at SUR/FIN 2016 in Las Vegas, Nevada on June 6, 2016. In this lecture, Dr. Melissa Klingenberg discusses additive manufacturing; that is, any manufacturing process capable ...

Published: 12/19/2017

Nickel: Science, Health and the Future - The 52nd William Blum Lecture
This presentation is the 52nd William Blum Lecture, presented at SUR/FIN 2015 in Rosemont, Illinois on June 8, 2015. In this lecture, Dr. Hudson Bates discusses the nickel research in his group at the Nickel Producers Environmental Research Ass...

Published: 12/19/2017

Surface Finishing Sustainability: Technology Pathways - The 51st William Blum Lecture
This presentation is the 51st William Blum Lecture, presented at SUR/FIN 2014 in Cleveland, Ohio on June 9, 2014. In this lecture, Dr. Yinlun Huang discusses the critical issue of sustainability in manufacturing with the primary focus on the surface...

Published: 12/19/2017

Decorative Electroplating: Theory to Explain Rapid Corrosion Due to Calcium Chloride ‘Russian Mud’ - The 48th William Blum Lecture
This presentation is the 48th William Blum Lecture, presented at SUR/FIN 2010 in Grand Rapids, Michigan on June 14, 2010. In this lecture, Dr. Donald Snyder describes the phenomena behind a new challenge to decorative Cu-Ni-Cr plating...

Published: 12/1/2017

The $178 Billion Plating Shop
Go inside the Plate Manufacturing Division of the U.S. Bureau of Engraving and Printing’s picturesque building at 14th Street SW in Washington, D.C. The BEP is this nation’s sole producer of U.S. paper currency, also known as Federal Res...

Published: 12/1/2017

Electrocoat Primer Takes Off in Aerospace
PPG’s Aerocron electrocoat system tops our list of the finishing products highlighted in 2017.

Published: 12/1/2017

Old School Ways for New Method Plating
Cadmium and die castings help a 86-year-old Massachusetts plating shop thrive.

Published: 11/18/2017

Electrodeposited Inconel and Stellite-like Coatings for Improved Corrosion Resistance in Biocombustors
This work deals with problems in the Third World – namely improving the safety and efficiency of cookstoves used by people around the world.  A scalable and economic process is required to apply coatings on low-cost stainless steel&n...

Published: 11/18/2017

Direct Metallization for Plating on Plastics
A new combination of copper immersion and autocatalytic copper-(I)-oxide deposition enables lower palladium concentrations in the activator bath, though the amount of copper deposited on the plastic surface can be up to ten times higher co...