#BASICS

Anodizing

Preventing Soil Contamination is Good Business For Witt Lining Systems

Manufactures flexible PVC liners used for corrosion resistance in process tanks, storage tanks, vats, sumps, pits and containment areas.
#pollutioncontrol #basics #management

Electroplating

Guarding Against Counterfeit Parts

We have been doing a lot of defense work lately and are concerned about counterfeit parts. How can we protect ourselves?
#basics #military #pollutioncontrol

Powder Coating

How to Measure Powder Value

What things should we consider as we evaluate different powder suppliers? How can we compare them so that we get the best material at the best possible price? How can we best determine the right source for our powder?
#basics

Liquid Coating

Paint Stripping Waste Disposal

In response to a question in the September 2012 column regarding the disposal of waste from paint stripping, one reader recommends purchase of a stripping oven, used to strip products and paint racks.
#pollutioncontrol #basics

Powder Coating

CCAI Presents "Basics of Powder Coating" in Spanish on April 16 in Miami

Conceptos Básicos de Pintura en Polvo en Español, to be held on Tuesday, April 16 at the American Welding Society Headquarters Conference Center in Miami, FL.
#basics #curing #masking

Liquid Coating

New Chromium Electroplating Housekeeping Requirements

Alert for Platers: Your Deadline is March 19, 2013 as EPA finalized the residual risk and technology review for the national emission standards for hazardous air pollutants (NESHAP) for hard and decorative chromium electroplating and chromium anodizing tanks under 40 CFR Part 63
#pollutioncontrol #basics

Electroplating

Copper Plating Basics

Can you supply me with a few references for information about cyanide and non-cyanide copper plating baths?
#basics

Electroplating

Evolution of Electroless Nickel Plating

What’s next for EN technology?
#basics

Electroplating

More Environmental Cases are Going Criminal

Surface finishers and others operating in industries highly regulated by federal, state and local environmental protection agencies have seen an increase in the number of violations that have escalated from administrative notices of violations and fines, or even civil penalties, to criminal prosecutions
#pollutioncontrol #basics #masking

Powder Coating

How to Limit Outgassing on Castings

I cannot find a way to powder coat aluminum castings without severe outgassing and blisters. Does the temperature have a role to play versus line speed? Will higher temperature emit more gas from the aluminum casting?
#basics

Liquid Coating

NASF Sues EPA Over Hex Chromium Rules

Sierra Club also sues the EPA over the same National Emission Standards for Hazardous Air Pollutants rules for plating industry; NASF's two court actions include a petition for judicial review of the ruling in the D.C. Circuit Court of Appeals, and a request for reconsideration of the rule with EPA.
#regulation #pollutioncontrol #basics

Liquid Coating

EHS Q&A: Waste Treatment for Paint Stripping

Q. We will be using concentrated sulfuric acid to strip e-coatings from reject metal parts ... Unfortunately, our only outlet for discharge of this waste is to a nearby storm drain, and we know that we will need to remove the paint sludge and color and to neutralize the pH before discharge. Can you advise?
#pollutioncontrol #basics #regulation

Liquid Coating

EPA Issues Chromium Air Rule, Despite NASF Meeting With White House Officials

The U.S. EPA signed the final chromium electroplating air rule Aug. 15 after it was finally cleared by the White House; the NASF says it might take the matter to court to overturn the rule.
#nasf #pollutioncontrol #basics

Liquid Coating

An Introduction to Cyclic Corrosion Testing

A more realistic way to perform salt spray tests.
#basics

Liquid Coating

EPA vs. NASF: The Continental Divide

EPA official attends NASF Washington Forum to speak on chromium rule and flawed data.
#regulation #pollutioncontrol #basics

Liquid Coating

EPA One Step Closer to Finalizing New Emission Standards

Attorney and environmental expert Anthony Giuliani explains the EPA's new chromium rules due in 2012, which would amend the existing National Emission Standards for Hazardous Air Pollutants Emissions for hard and decorative chromium electroplating and chromium anodizing tanks by lowering the existing NESHAP limits for both existing and new sources.
#sustainability #pollutioncontrol #basics

Parts Cleaning

NASF REPORT: Is EPA Playing Dirty With Chromium Data?

NASF’s Jeff Hannapel and Christian Richter point to major flaws, bad precedent in EPA chromium air rule. NASF leaders have submitted a 100-page package of comments to the EPA in response to the agency’s proposed rule for chromium finishing operations.
#basics #pollutioncontrol #regulation

Liquid Coating

Meeting the Critical Cleaning Challenge

Today’s parts cleaning industry faces numerous challenges that can make the selection of an effective critical cleaning system difficult
#basics

Liquid Coating

Are Ionic Liquids Right for Your Parts Cleaning Job?

Ionic liquids have also been considered for parts cleaning applications because of their negligible vapor pressure, high thermal and electrochemical stability, and low melting points of less than 100°C.
#vacuum-vapor #basics #workforce development

Electroplating

NASF Says EPA Chromium Air Rules Have Major Flaws

Claims EPA Used Data from 'Phantom Facilities'
#pollutioncontrol #basics #nasf